Search results for "Transfer molding"
showing 5 items of 5 documents
Bubble formation and motion in non-crimp fabrics with perturbed bundle geometry
2010
The behaviour of the fluid front during impregnation of non-crimp fabrics has been considered. Particular attention is paid to creation of bubbles at the fluid front and a virtual 3D model mimickin ...
Estimation of the tensile strength of an oriented flax fiber-reinforced polymer composite
2011
Unidirectional orientation of natural fibers in a polymer composite ensures the highest efficiency of reinforcement. Flax fiber reinforcement is discontinuous due to limited fiber length and heterogeneous due to the presence of elementary fibers and their bundles. In order to assess the upper limit of tensile strength of such slightly misoriented, nominally UD natural fiber composite, a statistical strength model of continuous UD fiber reinforced composites is applied. It is found that the experimental strength of UD flax composites, produced from rovings or manually aligned fibers, approaches the theoretical limit only at relatively low fiber volume fraction ca. 0.2, being markedly below i…
Bubble motion through non-crimp fabrics during composites manufacturing
2008
Bubbles motion through interbundle channels in biaxial non-crimp fabrics is modelled. The scenario is that formed bubbles move with the resin through these channels and are trapped if the channels become too narrow. By usage of a permeability network model, existing criteria on bubble deformation and a variety of analytical and probabilistic methods it is found that the paths of the bubbles depend significantly on the position of the threads keeping the fabric together and the number of fibres crossing the interbundle channels. Another result is that the pressure difference over a trapped bubble increases with 50% in a 3D geometry possible helping the bubble to escape. A third result is tha…
Stiffness and strength of flax fiber/polymer matrix composites
2006
Flax fiber composites with thermoset and thermoplastic polymer matrices have been manufactured and tested for stiffness and strength under uniaxial tension. Flax/polypropylene and flax/maleic anhydride grafted polypropylene composites are produced from compound obtained by coextrusion of granulated polypropylene and flax fibers, while flax fiber mat/vinylester and modified acrylic resin composites are manufactured by resin transfer molding. The applicability of rule-of-mixtures and orientational averaging based models, developed for short fiber composites, to flax reinforced polymers is considered. POLYM. COMPOS. 27:221–229, 2006. © 2006 Society of Plastics Engineers
Evaluation of interfacial shear strength by tensile tests of impregnated flax fiber yarns
2011
Adhesion of flax fibers and polymer matrix as well as mutual bonding of elementary fibers in a technical fiber are among the principal factors governing the mechanical response of flax fiber-reinforced polymer–matrix composites. A method for evaluation of adhesion is proposed based on tension tests of impregnated fiber yarns, with subsequent characterization by optical microscopy of length distribution of fibers pulled out of the yarn fracture surfaces. An elementary probabilistic model is derived relating aspect ratio distribution of the pulled-out fibers to the fiber tensile strength distribution and the effective interfacial shear strength (IFSS). The method was applied to flax fiber/vi…